Filter
Top Products
Before storing the GBC/GBCE Lighting System, perform
the following steps.
1. Disconnect the lamp connector from the AC power
cable.
2. Make sure the mast is completely lowered as described
in LOWERING THE MAST section.
3. Unhook the AC power cable from the eyelet at the
bottom of the balloon.
4. Lock the buckle to secure the balloon together.
5. Unzip the zipper on the protective cover and pull down
cover over the balloon/lamp assembly.
6. Place the AC power cable in the pocket inside the
protective cover and attach velcro tabs.
7. Loosen the T-bolt on the balloon/lamp assembly and
lift balloon/lamp assembly from the mast.
8. Release the lever on the mast holder and pull out the
mast.
9. Stow the three outriggers as detailed in the STOWING
OUTRIGGER section.
NOTICE
To turn lamp back on, unplug the power cable from
the power source. Wait three to five minutes before
reconnecting the power. Reconnect the power cable
and the lamp should turn on and the balloon will
inflate.
NOTICE
Allow about 15 to 20 minutes for the lamp to cool down
before storing the GBC/GBCE. The possibility exists of
the balloon getting burned if it touches a hot lamp.
OPERATION