Filter
Top Products
COMPONENTS
Figure 3 shows the location of the controls and components
for the GBC/GBCE Lighting System. The functions of each
control is described below:
1. — Stores balloon when GBC/GBCE
is not in use. Allow a sufficient amount of time for the
lamp to cool down before storing balloon. Possibility
exists of balloon getting burned.
2. — Made of heat resistant polyester, with a
diameter of 47.2 inches (1,200 mm). Balloon is self-
inflating and inflates in less than 20 seconds.
3. — Used to easily attach optional message strip
to the balloon.
4. — Used to hold the balloon together when
storing inside the cover.
5. — connects to the AC power source
(generator) on one end and to the lamp connector on
the other end with quick-disconnect connector.
6. — holds the generator and can be steered easily
to transport GBC/GBCE to different locations.
7. — To secure the generator to the cart
platform, place clamps around the pipe frame of the
generator. Tighten securely to prevent movement.
8. — The GBC/GBCE uses four pneumatic tires for
easy maneuverability.
9. — When the brake pedal is pressed, this
pad will strike and hold the rear tires in place.
10. — Allows suitcase generators to be
strapped to cart securely.
11. — provides stability to the GBC/GBCE.
When raising the mast, outriggers should always be
deployed.
12. — Locks the outriggers in place when
they are deployed or stowed.
13. — Step on this pedal and pull back
T-handle to apply the brakes. To release the brakes,
press down and hold brake pedal again then release.
14. — Moves the GBC/GBCE in either forward
or reverse direction by pulling back or pushing forward.
The T-handle also allows the cart to be steered left or
right.
15. — This mast is comprised of three separate
stages. The mast can be raised in excess of 8 feet
(without balloon).
16. — Loosen to raise mast and tighten to keep
the mast in place when raised to the desired height.
17. — Connect this quick-
disconnect plug to the balloon connector.
18. — a 12 x 43 inch
message strip (Part No. GBBALD1) may be attached
to the balloon. The message strip can be purchased
separately.
19. — Zips up balloon to completely close it when
lamp is in place.
20. — Holds lamp in place. Lamp is screwed
into socket.
21. — Connect this connector to the
AC power cable connector.
22. — used to tighten mast when
attached to the lamp/balloon assembly.
23. — inflates the balloon as soon
as power is applied to the GBC/GBCE.
24. — 1000 watt metal halide bulb with pure white
light for maximum illumination.
25. — Protects the lamp from being hit by
objects and balloon material from touching lamp.
26. — Extends mast height
by 40 inches.
When raising the mast, always be on the lookout for
overhead obstructions.