Filter
Top Products
1. Loosen the T-bolt holding the second mast and push
mast all the way down. Tighten T-bolt securely. See
Figure 21.
Figure 21. Lowering Second Mast
2. Push the lock/release tab on the third mast to release
it and lower third mast. See Figure 22.
Figure 22. Lowering Third Mast
1. Connect the AC power cable to the 120 VAC receptacle
on the generator used. See Figure 23.
Figure 23. Connecting to Power Source
2. Start the generator as indicated in the generator
manual. The balloon will start to inflate and the lamp
will turn on.
T-BOLT
SECOND
MAST
THIRD
MAST
LOCK/
RELEASE
TAB
20A
120V
120 VAC
RECEPT
ACLE
POWE
R
CABLE
TYPICAL
GENERATOR
FRONT P
ANEL
OPERATION
1. Turn off the power switch of the generator.
2. Disconnect the AC power cable from the generator.
The balloon should start to deflate and the lamp will
turn off.
1. Unzip the bottom of the balloon. See Figure 24.
Figure 24. Unzipping Balloon
2. Push the button above the LED with a blunt object for
three seconds as shown in Figure 25. LED will turn
red and the lamp will turn off. The balloon will remain
inflated.
Figure 25. Turning Off Lamp Only
NOTICE
If the power cable is accidentally unplugged from
the power source, wait three to five minutes before
reconnecting the power. This will allow time for the fan
to reset and ensure balloon will inflate properly when
power is reconnected.
ZIPPER
BALLOON
PUSH WITH
BLUNT OBJECT
LED