Filter
Top Products
GENERATOR SHUT-DOWN PROCEDURES
To shutdown the generator, use the following procedure:
1. Place both the circuit breakers
as shown in Figure 35 to the position.
2. Place the engine speed switch (Figure 53) in the “LOW”
(down) position.
Figure 53. Engine Speed Switch (Low)
3. Let the engine cool by running it at low speed for 3-5
minutes with no load applied.
4. Place the (Figure 54) to the
position.
Figure 54. MPEC Control Switch (Off/Reset)
5. Verify that all the status LEDs on the MPEC display
are (not lit).
6. Remove all loads from the generator.
7. Inspect entire generator for any damage or loosening
of components that may have occurred during
operation.
stop the engine suddenly except in an
emergency.
1. To stop the engine in the event of an emergency, PUSH
the emergency stop button (Figure 55) inward. This
button is located on the engine operating panel, see
Figure 5.
Figure 55. Emergency Stop Button