Filter
Top Products
PAGE 36 — DCA-220SSK — PARTS AND OPERATION MANUAL (STD) — REV. #3 (06/05/01)
elbaliavAsegatloV.8elbaT
egatloVesahP3
)elbatcennoceR(
TLOV802TLOV022TLOV042TLOV614TLOV044TLOV084
esahPelgniS
)elbatsujdA(
TLOV021TLOV721TLOV931TLOV042TLOV452TLOV772
Output Terminal Panel Available Voltages
A wide range of voltages are available to supply load to
many different applications. Voltages may be selected by
using the voltage selector switch and how you hookup
your hard wire connection to the generator. To obtain some
of the voltages listed, fine adjustment with the Voltage
Regulator on the control panel is necessary. See the table
below (Table 8) for a list of available voltages the generator
is able to supply.
Voltage Selector Switch
The voltage selector switch is located above the UVWO
Hard Wire Hookup Panel. It has been provided for ease of
voltage selection.
CAUTION :
NEVER switch Voltage Selector Switch
position while the engine is engaged.
Voltage Selector Switch Locking Button
The voltage selector switch has a locking button to protect
the generator and generator load from being switched while
the engine is running. To lock the Voltage Selector Switch,
press in the red button located on the Voltage Selector
Switch, and use a pad lock to hold it into this position
(See Figure 17, page 37).
Over Current Relay
An over current relay is connected to the circuit breaker.
In an over current situation, both the circuit breaker and
the over current relay may trip. If the circuit breaker can
not be reset, the reset button on the over current relay
must be pressed. The over current relay is located in the
control box.
spmAmumixaM.9elbaT
detaR
egatloV
spmAmumixaM
esahPelgniS
tloV021
)eriw4(spma9.884
esahPelgniS
tloV042
)eriw4(spma4.442
esahPeerhT
tloV042
spma3.925
esahPeerhT
tloV084
spma6.462
Maximum Amps
The following table show the maximum amps the entire
generator can provide. Do not exceed the maximum amps
listed (See Table 9 below).
DCA-220SSK — OUTPUT TERMINAL PANEL OVERVIEW
Table of Contents