Filter
Top Products
®
To shutdown the generator, use the following procedure:
1. Place the circuit breakers
(Figure 38) in the OFF position.
Figure 38. Main, Aux. and GFCI
Circuit Breakers (OFF)
2. Let the engine cool by running it at low speed for 3-5
minutes with no load applied.
stop the engine suddenly except in an
emergency.
GENERATOR SHUT-DOWN PROCEDURES
3. Place the (Figure 39) to the
position.
Figure 39. MPEC Control Switch (Off/Reset)
4. Verify that all the status LEDs on the MPEC display
are OFF (not lit).
5. Remove all loads from the generator.
6. Inspect entire generator for any damage or loosening of
components that may have occurred during operation.
1. Place the circuit breakers
(Figure 38) in the OFF position.
AUTO
MANUAL
OFF/RESET