Filter
Top Products
PAGE 26 — DCA20SPXU2 SERVPRO
®
OUTPUT TERMINAL PANEL CONNECTIONS
240/120V outout voltages can be obtained using the output
terminal lugs.
The voltage regulator (VR), Figure 15 allows the user to
increase or decrease the selected voltage.
1. Connect the load wires to the output terminal lugs as
shown in Figure 14.
Figure 14. Output Terminal Lugs
1Ø-240 Volt Connections
2. Turn the voltage regulator knob (Figure 15) clockwise
to increase voltage output, turn counterclockwise to
decrease voltage output. Use voltage regulator
adjustment knob whenever fine tuning of the output
voltage is required.
Figure 15. Voltage Regulator Knob
1. Connect the load wires to the output terminal lugs as
shown in Figure 16.
Figure 16. Output Terminal Lugs
1Ø-120 Volt Connections
2. Turn the voltage regulator knob (Figure 15) clockwise
to increase voltage output, turn counterclockwise to
decrease voltage output.
NOTICE
make sure that the connections to the UVO
terminal lugs are and tight. The possibility of
arcing exists, that could cause a fire.