Multiquip DCA-100SSJU Portable Generator User Manual


 
DCA-100SSJU PARTS AND OPERATION MANUAL (STD) REV. #2 (05/03/01) PAGE 29
DCA-100SSJU CONTROL PANEL
The definitions below describe the controls and functions of
the DCA-100SSJU "
Control Panel
" (Figure 8).
1. Main Circuit Breaker This three-pole, 250 amp main
breaker is provided to protect the UNV voltage output
terminals from overload.
2. AC Ammeter Indicates the amount of current the
load is drawing from the generator.
3. Ammeter Change-Over Switch This switch allows
the AC ammeter to indicate the current flowing to the
load connected to any phase of the output terminals, or
to be switched off.
4. Voltmeter Change-Over Switch This switch allows
the AC voltmeter to indicate phase to phase voltage
between any two phases of the output terminals or to
be switched off.
5. Voltage Regulator Control Allows manual
adjustment of the generators output voltage.
6. Frequency Meter Indicates the output frequency in
hertz (Hz). Normally 60 Hz ±1 Hz .
7. AC Voltmeter Indicates the single phase output
voltage present at the UNV terminals.
Table of Contents