Filter
Top Products
CA4HC WALK-BEHIND TROWEL — OPERATION MANUAL — REV. #0 (09/29/06) — PAGE 15
CA4HC TROWEL— GENERAL INFORMATION
CA4HC Trowel Familiarization
This walk-behind trowel is designed for the
floating
and
finishing
of concrete slabs.
Take a walk around the trowel. Take notice of all the major
components (see Figure 2) like the engine, blades, Standard or
Quick Pitch™ handle, etc.
Read
all the safety instructions carefully. Safety instructions will
be found throughout this manual and on the trowel. Keep all
safety information in good, readable condition. Operators should
be well trained on the operation and maintenance of the trowel.
Before using your trowel, test it on a flat watered down section of
finished concrete that is free of any debris and other objects.
This trial test run will increase your confidence in using the trowel
and at the same time it will familiarize you with the trowel’s
controls. In addition you will understand how the trowel handles
under actual conditions.
Engine
This trowel is available with an 4 HP
HONDA gasoline engine
.
Refer to the engine owner’s manual for instructions regarding
the operation and maintenance of your engine. Please contact
your nearest Multiquip Dealer for a replacement should the
original manual disappear or otherwise become unusable.
Training
For proper training, please use the “TRAINING CHECKLIST”
located in the front of this manual (Page 8). This checklist will
provide an outline for an experienced operator to provide training
to a new operator
Blades
The blades of the trowel finish the concrete as they are rotated
around the surface. This trowel comes equipped with four
combination
(8 in./203mm wide)
blades
per rotor equally
spaced in a radial pattern and attached to vertical rotating
shaft by means of the spider assembly
.
Centrifugal Clutch
In the event of a trowel runaway condition (operator releases
the handle), a
centrifugal clutch
will stop the engine and
bring the trowel to a halt.
Drive System
Power is transferred from the engine to the gearbox input shaft
via a
V-belt pulley drive system
. The pulley engages using a
centrifugal clutch. See Parts section of this manual.
Gearbox
The
gearbox
is located beneath the engine and transfers power
to the spider assembly. The gearbox controls the rotational speed
of the trowel and is equipped with two shafts (input and output).
Guard Ring
This unit is equipped with a special rotating
guard ring
. It is
designed to allow the operator to run the machine alongside
walls, pipes, and obstructions without marring the surface.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NEVER attempt to
lift
the trowel by yourself. ALWAYS get
the assistance of another person to help lift the trowel .
Operate the CA4HC Trowel, tools and components in accordance
with the manufacturer's instructions. Use of any other tools for
stated operation is considered contrary to designated use. The
risk of such use lies entirely with the user. The manufacturer
cannot be held liable for damages as a result of misuse.
Intended Use
Spider
The vertical output shaft of the gearbox connects to a machined
hub called the
spider
. The spider has 4 arms that extend outward
that are used for attachment of blades or other accessories.
Remember as the gearbox output shaft rotates so does the spider
assembly.