Filter
Top Products
always be in place while operating the
unit. Do not operate unit without both
trimming lines extended, and the proper
line installed. Do not extend the trimming
line beyond the length of the shield.
• This unit does not have a clutch. The
cutting attachment continues rotating
when the engine is idling. If it does not,
have the unit adjusted by an authorized
service technician.
• Adjust the D-handle to your size in
order to provide the best grip.
• Be sure the cutting attachment is not in
contact with anything before starting
the unit.
• Use the unit only in daylight or good
artificial light.
• Avoid accidental starting. Be in the
starting position whenever pulling the
starter rope. The operator and unit must
be in a stable position while starting.
Refer to Starting/Stopping Instructions.
• Use the right tool. Only use this tool for
its intended purpose.
• Do not overreach. Always keep proper
footing and balance.
• Always hold the unit with both hands
when operating. Keep a firm grip on
both handles or grips.
• Keep hands, face, and feet at a distance
from all moving parts. Do not touch or
try to stop the cutting attachment when
it rotates.
• Do not touch the engine, gear housing
or muffler. These parts get extremely
hot from operation, even after the unit
is turned off.
• Do not operate the engine faster than
the speed needed to cut, trim or edge.
Do not run the engine at high speed
when not cutting.
• Always stop the engine when cutting is
delayed or when walking from one
cutting location to another.
•I
f you strike or become entangled with a
foreign object, stop the engine immediately
and check for damage. Do not operate
before repairing damage. Do not operate
the unit with loose or damaged parts.
• Stop the unit, switch the engine to off,
and disconnect the spark plug for
maintenance or repair.
•U
se only original equipment manufacturer
replacement parts and accessories for this
unit. These are available from your
authorized service dealer. Use of any
unauthorized parts or accessories could
lead to serious injury to the user, or damage
to the unit, and void your warranty.
•K
eep unit clean of vegetation and other
materials. They may become lodged
between the cutting attachment and shield.
• To reduce fire hazard, replace a faulty
muffler and spark arrestor. Keep the
engine and muffler free from grass, leaves,
excessive grease or carbon build up.
OTHER SAFETY WARNINGS
• Never store a fueled unit inside a
building where fumes may reach an
open flame or spark.
• Allow the engine to cool before storing
or transporting. Be sure to secure the
unit while transporting.
• Store the unit in a dry area, locked up
or up high to prevent unauthorized use
or damage, out of the reach of children.
• Never douse or squirt the unit with
water or any other liquid. Keep handles
dry, clean and free from debris. Clean
after each use, see Cleaning and
Storage instructions.
• Keep these instructions. Refer to them
often and use them to instruct other
users. If you loan someone this unit,
also loan them these instructions.
SAVE THESE INSTRUCTIONS
RULES FOR SAFE OPERATION
4