Filter
Top Products
24 se c t i O n 7— se r v i c e24 se c t i O n 7— se r v i c e
cutting deck by removing the hair pin clip which secures it.
Remove the spring from the deck idler bracket. See Fig. 7-5
Gently slide the cutting deck 10. (from the left side) out from
underneath the tractor.
Tires
Never exceed the maximum inflation
pressure shown on the sidewall of tire.
The recommended operating tire pressure is:
Approximately 10 psi for the rear tires
Approximately 14 psi for the front tires
Refer to the tire sidewall for exact tire
overinflate. Uneven tire pressure could cause the cutting deck to
mow unevenly.
Battery
!
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
If removing the battery, disconnect the
(Red) wire its terminal first, followed by the
7.
side of the tractor, locate the deck support pin on the rear
release the deck from the deck lift arm. See Fig. 7-3.
8.
7.
the right fender to raise the deck lift arms up and out of the
way.
8.
front of the tractor carefully guiding the hooks on the deck
off of the deck stabilizer rod.
securing the deck stabilizer rod to the deck. Slide the deck
lift rod from the mounting weldment on the deck as seen
in Fig. 7-4.