Maintenance
position, set parking brake, stop engine and remove
key to prevent unintended starting.
Engine
maintenance instructions.
Check engine oil level before each use as instructed in the Engine
instructions carefully.
Changing Engine Oil
Manual. To drain the oil, proceed as follows:
Unscrew the oil fill cap and remove the dipstick from the oil 1.
fill tube.
Snap the small end of oil drain sleeve onto the oil sump. 2.
See Fig. 6-1.
Remove drain plug and drain oil into a suitable container 3.
with a capacity of no less than 64 oz.
Service oil filter 4. (if so equipped) as instructed in the separate
finished draining.
Refill the engine with new motor oil as instructed in the 5.
NOTE:
your unit for information regarding the quantity and proper
viscosity of motor oil.
Air Cleaner
Service the pre-cleaner, if so equipped, and cartridge/air cleaner
packed with your unit.
Spark Plug
The spark plug should be cleaned and the gap reset once a
season. Spark plug replacement is recommended at the start
Manual for correct plug type and gap specifications.
Lubrication
into neutral position, set parking brake, stop engine
and remove key to prevent unintended starting.
Engine
Lubricate the engine with motor oil as instructed in the Engine
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Rear Wheels
The rear wheels should be removed from the axles once a
season. Lubricate the axles and the rims well with an all-purpose
grease before re-installing them.
Front Axles
grease fitting. Lubricate with a grease gun after every 25 hours of
tractor operation.
Battery
The battery is sealed and is maintenance-free. Acid levels cannot
be checked.
Always keep the battery cables and terminals clean and
free of corrosive build-up.
After cleaning the battery and terminals, apply a light coat
of petroleum jelly or grease to both terminals.
Always keep the rubber boot positioned over the positive
terminal to prevent shorting.
If removing the battery for any reason,
wires are connected to the correct terminals; reversing them
alternating system.
Maintenance & Adjustments
6
19