Filter
Top Products
16 se c t i O n 5— Op e r a t i O n
4. (indicator light ON), the tractor can be driven
in reverse with the cutting blades (PTO) engaged.
Always look down and behind before and while backing to 5.
make sure no children are around.
After resuming forward motion, return the key to the 6.
activated until:
a.
The operator engages the parking brake by fully b.
depressing the clutch-brake pedal and holding it
down while moving the speed control lever into the
Engaging the Parking Brake
To engage the parking brake:
Fully depress the clutch-brake pedal and hold it down with 1.
your foot.
Move the speed control lever all the way down and into the 2.
parking brake position.
Release the clutch-brake pedal to allow the parking brake 3.
to engage.
To release the parking brake:
Depress the clutch-brake pedal and move the speed 1.
control lever out of the parking brake position and into a
desired speed.
Setting the Cutting Height
Select the height position of the cutting deck by placing 1.
the deck lift lever in any of the six different cutting height
notches on the right side of the fender.
Adjust the deck wheels as instructed in the Assembly & Set-2.
Up section earlier in this manual, if equipped, so that they
are between ¼-inch and ½-inch above the ground when
the tractor is on a smooth, flat surface such as a driveway.
Keep hands and feet away from the
discharge opening of the cutting deck.
NOTE:
feature of the deck and are not designed to support the weight
of the cutting deck. Refer to Leveling in the Maintenance section
of this manual for more detailed instructions regarding various
deck adjustments.
Starting the Engine
Do not operate the tractor if the
interlock system is malfunctioning. This system was
designed for your safety and protection.
NOTE:
Insert the tractor key into the ignition switch.1.
2. (Blade Engage)
position.
3.
Activate the choke control.4.
Turn the ignition key clockwise to the START position. After 5.
(or
Normal Mowing) position.
position for longer than ten seconds at a time. Doing
starter.
After the engine starts, deactivate the choke control and 6.
place the throttle control in the FAST position.
NOTE:
tractor. Doing so will result in a “rich” fuel mixture and cause the
engine to run poorly.
Stopping the Engine
If you strike a foreign object, stop the
engine, disconnect the spark plug wire(s) and
ground against the engine. Thoroughly inspect the
machine for any damage. Repair the damage before
restarting and operating
1. (Blade Engage)
2.
position.
Remove the key from the ignition switch to prevent 3.
unintended starting.
16