Cleaning Battery
Clean the battery by removing it from the tractor and washing
with a baking soda and water solution. If necessary, scrape the
battery terminals with a wire brush to remove deposits. Coat
terminals and exposed wiring with grease or petroleum jelly to
prevent corrosion.
Battery Failures
Some common causes for battery failure are:
Incorrect initial activation
Freezing
Undercharging
Corroded connections
Cleaning the Engine And Deck
Any fuel or oil spilled on the machine should be wiped off
fins of the engine or on any other part of the machine.
The use of a pressure washer to clean your
components, spindles, pulleys, bearings or the engine.
replaced with a water port to be used as part of a separately-
available deck wash system.
The Deck Wash System™ is used to rinse grass clippings from the
NOTE: Refer to the Attachments & Accessories section of this
manual for information regarding this and other separately-
available attachments & accessories for your tractor.
Deck Wash System™
as part of its Deck Wash System™, follow these instructions to
utilize this feature.
Use the Deck Wash System™ to rinse grass clippings from the
Drive the tractor to a level, clear spot on your lawn, near 1.
enough for your garden hose to reach.
chute is directed AWAY from your house, garage,
parked cars, etc.
2. (Blade Engage), set the parking brake
and stop the engine.
Thread the hose coupler 3. (packaged with your tractor’s
Operator’s Manual) onto the end of your garden hose.
4.
surface. See Fig. 6-3.
Turn the water on.5.
6.
the engine and place the throttle lever in the FAST (rabbit)
position.
7. (Blade Engage)
8.
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
(Blade Engage)
position.
10.
Turn the water off and detach the hose coupler from the 11.
12.
side of the cutting deck.
20 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t s