Filter
Top Products
1211
5. Wind the line onto the spool by turning the spool. The
line should go on in the direction of the arrow (A) on
the spool (Fig. 20). Line should be wrapped tightly
ar
ound the spool. The line is wound with each half
separated by the divider
. Tightly wind it until there is
about 6" of line left (Fig. 21).
6. Lock the ends of the line in opposite slots on the
spool (Fig. 22). Place the clear plastic line retainer
back over the line and spool (Fig. 23). Pull the lower
line up into the lower slot in the clear plastic line
retainer (Fig. 24). Pull the upper line down into the
upper slot (Fig. 25).
7. Insert the line through each eyelet in the spool carrier
and slide the spool into the carrier. (Fig. 26)
NOTE: Ensure that the line is within the clear plastic
line retainer. If it's outside of the clear plastic line
retainer, the line will not feed.
MAINTENANCE INSTRUCTIONS
8. Make sure to insert the spring, assemble the spool
and spool carrier back onto the trimmer. To do so,
push the head on and turn it clockwise until it locks.
(Fig. 27 and Fig. 28)
9. To test if the line is advancing properly, push the but-
ton with your thumb while pulling the line with your
fingers. The line should advance freely. (Fig. 29).
10. In the event of the line breaking inside the spool,
repeat the replacement operation.
11. Start the grass trimmer following the instructions in
the “STARTING” section.
MAINTENANACE
1. Regular cleaning and maintenance of your string trim-
mer will ensure efficiency and prolong the life of your
machine.
2. After each cutting operation, take apart and clean out
the grass and soil from: the spool and its slot, the
whole trimmer and in particular the guard.
3. During operation, keep the air slots clean and free of
grass.
4. Only use a cloth soaked with hot water and a soft
brush to clean the string trimmer.
5. Do not spray or wet the appliance with water.
6. Do not use detergents or solvents as these could ruin
the trimmer. The parts in plastic can easily be dam-
aged by chemical agents.
7. If the line cutting blade no longer cuts or breaks, have
this replaced by contacting an professional service
center.
8. This appliance has no internal serviceable parts. Do
not attempt any repairs. Doing so could create a haz-
ard and void the manufacturer’s warranty.
MAINTENANCE INSTRUCTIONS
Fig. 20
Fig. 21
A
Fig. 27
Fig. 28
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 26
Fig. 29
Before carrying out
any maintenance
operations, cut off the electric power supply by
disconnecting the battery pack from the hous-
ing.
CAUTION:
The line cutting
blade can give deep
cuts. For repairs which have not been
explained in these instructions, contact a pro-
fessional service center.
CAUTION: