Filter
Top Products
8
NOTE: Certain engines may also be equipped with an
on/off switch.
• Disconnect spark plug wire and ground against the
engine to prevent unintended starting.
Figure 7
SECTION 4: OPERATING YOUR LOG SPLITTER
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
WARNING: Wear leather work gloves,
safety shoes, ear protection, and safety
glasses when operating log splitter.
Ensure safe footing.
Gas And Oil Fill-Up
Service the engine with gasoline and oil as instructed in
the separate engine manual packed with your log
splitter. Read instructions carefully.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running.
NOTE: Gasoline can be added to the engine when the
log splitter is in either the horizontal or vertical position;
however, there are less obstructions when the unit is in
the vertical position.
Starting Engine
• Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug wire is
fastened securely over the metal tip on the spark
plug.
• Engines with choke lever:
Move choke lever on engine to CHOKE position.
(A warm engine may not require choking).
NOTE: Certain engines may be equipped with an on/off
switch. Check your separate engine manual to verify
engine controls.
• Engines with primer:
Prime engine as instructed in separate engine
manual.
• The throttle control lever is located on the engine.
Move engine throttle control lever to FAST or
START position.
• Grasp starter handle and pull rope out slowly until
engine reaches start of compression cycle (rope
will pull slightly harder at this point).
• Pull rope with a rapid, continuous, full arm stroke.
Keep a firm grip on starter handle. Let rope rewind
slowly.
• Repeat the previous steps until engine fires. When
engine starts, move choke control (if equipped)
gradually to RUN position.
• If weather is cold, run wedge up or down beam 6 to
8 times to circulate the hydraulic fluid.
WARNING: When starting a warm engine,
the muffler and surrounding areas are hot
and can cause a burn. Do not touch.
Splitting Wedge
Vertical
Position Lock
Horizontal
Position Lock
Control Handle
Reverse
Neutral
Forward