Filter
Top Products
SYMPTOM
POSSIBLE CAUSE(S)
SOLUTION
Engine fails to start
1. Check fuel tank for gas.2.
Spark plug lead wire
disconnected.3.
Faulty spark plug.
1. Fill tank if empty.
2. Connect lead wire.
3.
Spark should jump gap between
control electrode and side elec-
trode. If spark does not jump,
replace the spark plug.
Hard starting or loss of
power
1. Spark plug wire loose.
2. Dirty air cleaner.
1. Connect and tighten spark plug
wire.2.
Clean air cleaner as described in
engine manual.
Engine
overheats
1. Carburetor not adjusted
.properly.
2. Air flow restricted.
~Engine
oil revel low.
1. Adjust carburetor. See engine
manual.2.
Remove blower housing and clean
as described in the engine
manual.3.
Fill crank~V!ith the proper oil.
Controls do not engage
Belts worn and/orstretched.
Make control cable adjustment
(see adjustment section) or replace
belts.
NOTE: For repairs beyond the minor adjustments listed above, please contact your local service dealer.
15