Filter
Top Products
Wheel Chain
Case Pulley
/ 1-1
Small I
Pulle
L
)
J
~
Wheel Chain
Case Pulley Forward
.~ve Belt
rSOl~1
tr'
If,
J/-
'",.
~ "
~ ~'
'~ -~
: -;')
'"
6)
{2)\~~
~
~L
< ...~
~~,"'~
'- --'.'- \~
Reverse Drive I)
~J;
--~
-'"
--:::c:;:
Two-Step
Engine Pulley
-\-
Forward
Engine Pulley
~
" I
FIGURE 25.
FIGURE 23.
Reassemble new belts, following instructionsin
reverse order.
IMPORTANTWhen
reassembling belts, be certain
belts are routed around all belt
keeper pins as shown in figure 26.
4.
To remove the forward drive belt, proceed as
follows.
A. Loosen (do not remove) the hex nut at the
top of the wire belt keeper.
B. Pull bottom of wire belt keeper out and
then upward, pivoting it away from the for-
ward engine pulley. See figure 24.
FIGURE 24.
NOTE
Upon reassembly, refer to illustra-
tion on page 18 for correct assembly
of wire belt guard for your modeltiller.
C.
Lift belt off the forward engine pulley. See
figure 25.D.
Remove belt from inside sheave of wheel
chain case pulley.
13