22 43D0122
Pins
DO NOT sprinkle volcanic rock on the
logs or around the pilot or the main
burner. This may cause sooting. Place
volcanic rock only on the fl oor of the
fi replace.
During initial operation of the new
heater, burning logs will give off a paper
burning smell and orange fl ames will
be present. Simply open the windows
for a few hours to vent the odor.
CAUTION
LOG PLACEMENT
INSTALLING LOG ON GRATE (See Figure17)
Carefully place one-piece log on grate over two log-
positioning pins as shown.
PLACING THE DECORATIVE ROCK
The positioning of the logs are critical to the safe and clean operation of this
heater. Sooting and other problems may result if the logs are not properly and
fi rmly positioned in the appliance. Never add additional logs or embellishments
such as pine cones, vermiculite or rock wool to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only
parts specifically approved for this heater may result in property damage or
personal injury.
Before you begin — This unit is supplied with one ceramic fi ber log. Do not handle the log with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fi bers. After handling the log, wash your hands gently
with soap and water to remove any traces of fi bers.
WARNING
Figure 17 - Installing Logs to Grate