Filter
Top Products
1
1. OVERVIEW
This manual describes how to install AJ65BT-D75P2-S3 Positioning
Module (hereafter abbreviated as D75P2) and how to wire them with
external devices.
After unpacking D75P2, please confirm that the following products are
contained.
2. PERFORMANCE SPECIFICATIONS
The performance specifications for the D75P2 are shown below.
Refer to CPU module User's Manual to use for D75P2 general
specifications.
IMPORTANT
1) The following software packages will be needed if a D75P2 is to be used:
For DOS/V personal computers : SW1IVD-AD75P or later
2) Software version D or later will be required for AD75TU.
Model name Quantity
(Main module) AJ65BT-D75P2-S3 1
(Connector for external wiring) 10136-3000VE 2
(Connector cover) 10336-52F0-008 2
Item Specifications
Maximum output pulse
When connected to a differential driver: 400kpps
When connected to an open collector: 200kbps
Maximum connection
distance between servos
When connected to a differential driver: 10m (32.81 ft.)
When connected to an opem collector: 2m(6.56 ft.)
Type of CC-Link station Intelligent device station
Number of occupied station 4 stations (RX/RY each 128 points,RWr/RWw each 16 points)
External power supply 24 V DC (20.4 to 26.4 V DC)
Applicable wire size 0.75 to 2.00 mm
2
Module installation screws
Over M4 × 0.7 mm(0.03 in) × 16 mm(0.6 in)
DIN rail attachment is possible
Applicable DIN rails TH35-7.5Fe, TH35-7.5AI, TH35-15Fe (conforms to JIS-C2B12)
Applicable solderless terminal RAV 1.25-3.5, RAV 2-3.5
24 V DC internal current
consumption
0.30 A
Noise durability
Noise voltage 500 Vp-p, noise width 1 μs
(by the noise simulator with the noise frequency 25 to 60 Hz)
Dielectric withstand voltage
Batch power supply/communication type-batch external I/O,
500 V AC for 1 minute
Insulation resistor
Batch power supply /communication type batch external I/O,
500 V DC 10 m Ω or more by the insulation resistance tester.
External dimensions 63.5[2.5](H) × 170[6.7](W) × 80[3.1](D) mm [inch]
Weight 0.50 [1.1] kg [lb]