Filter
Top Products
34
students would have to manually slew to the last two objects. He would then place AUTO SLEW
ON before his first required object and AUTO SLEW OFF after the fourth object.
#END
To end a tour, type the command #END on a separate line at the very end of the tour.
Downloading Tours
Once a tour is written and stored as an ASCII file (saved either as a "text only" or "MS DOS
text" file), load it into Autostar using the Autostar Update Utility on your PC. As tours are
downloaded into the handbox, Autostar examines the programming. If it doesn't understand the
terminology used within a tour, it flags questionable areas and displays them in a pop-up win-
dow on your computer screen. Make the necessary corrections and try to download again. See
the instruction sheet with your #505 Cable Connector Kit for more information about
downloading data to and interfacing with Autostar.
Landmarks
This menu option allows you to define and store terrestrial objects in the Landmark database.
First, a landmark needs to be stored in memory using the "Landmark: Add" option. To view a
landmark, use the "Landmark: Select" option. Landmarks may also be viewed using the
"Landmark Survey" option in the Utilities menu.
To Add a landmark to the database:
In this procedure, you will store the location of terrestrial landmarks in Autostar's memory.
1. Set the telescope in the home position, if necessary. Note for future reference where the
telescope is located and if you have aligned the telescope, which alignment method is used.
IMPORTANT NOTE: To use the Landmark function, the telescope must be located
and aligned exactly as when the landmark(s) was added to the database.
2. Display the "Setup: Targets" menu option. Chose "Terrestrial" and press ENTER. "Setup:
Targets" displays again. Choosing this option turns off tracking for astronomical objects
and is not useful for the viewing of terrestrial objects such as those in the Landmark
database. Be sure to change this option back to "Astronomical" when you wish to view
celestial objects again.
3. Press MODE once. "Select Item: Setup" displays.
4. Press the Scroll Down key once and "Select Item: Object" displays. Press ENTER. "Object:
Solar System" displays.
5. Press the Scroll Up key twice and "Object: Landmarks" displays. Press ENTER.
"Landmark: Select" displays.
6. Press the Scroll Down key once. "Landmark: Add" displays. Press ENTER.
7. "Landmark Name" displays. Using Arrow keys, enter a name for the landmark you wish to
add to the database. When finished, press ENTER.
8. "Center Landmark. Press Enter" displays. Using only the Arrow keys (do not manually
move the telescope), move the telescope to the desired landmark and center the object in
the eyepiece. Press ENTER. The object is now stored in memory.
9. "Landmark: Add" displays. If you wish to add more landmarks, repeat steps 5 through 7.
To Select a landmark from the database:
1. Make sure the telescope is located and aligned exactly as when the desired landmark was
entered into memory.
2. Display the "Landmark: Select" menu option. Press ENTER.