Meade DS-2000 Telescope User Manual


 
4
QUICK-START GUIDE
1. Open the tripod: Remove the tripod from the gift-
box and stand vertically. Gently pull the legs apart
to a fully open position. Turn the center tripod lock
knob to secure and stabilize the tripod. Tighten to
a firm feel. Caution: Make sure you loosen the
tripod lock knob before collapsing the tripod
at the end of your viewing session.
2. Attach the mounting arm assembly: Place the
mounting arm assembly into the tripod base.
Reach underneath and thread the mounting knob
through the tripod base and into the mounting
arm assembly. Tighten to a firm feel only, do not
overtighten. While observing, you may wish to
slightly loosen this knob and rotate the mounting
arm assembly with attached optical tube (see
step #6 below) around the horizontal axis.
6. Attach and balance the optical tube: Replace
the optical tube into the cradle ring. Tighten the
cradle rings lock knob so that it holds the optical
tube loosely; do not tighten the cradle ring lock
knob at this point. Slide the tube back and forth
until you find a position where the tube remains
horizontal (i.e., without tipping up and down).
Tighten the cradle rings lock knob to a firm feel.
4. Remove 4 screws from the mounting arm
shaft: Locate the four screws on the mounting
shaft. Remove the screws using a "+" (Phillips
head) screwdriver.
5. Attach the cradle to the mounting arm: Line up
the cradle with the mounting arm shaft. The cra-
dle contains a molded "key" that fits into a slot on
the shaft. Line up the key and the slot, and slide
the cradle onto the shaft. This automatically lines
up the mating threads on the cradle with the ones
on the shaft. Replace the four screws you
removed in step #4 into the mating threads as
depicted in the diagram above.
3. Remove the optical tube assembly from the
cradle rings: The optical tube assembly is
shipped with the cradle rings attached. The rings
need to be removed so they can be attached to
the mounting arm. Loosen the cradle lock knob
until you can open the cradle rings. Remove the
optical tube assembly from the cradle rings.
1
2
3
4 & 5
6
7a
C
A
B
E
D
F