Filter
Top Products
Repair
P 2/ 8
[2] ASSEMBLY/ DISASSEMBLY
[2]-1. Handle section
[1] NECESSARY REPAIRING TOOLS
DescriptionCode No. Use for
Round bar for Arbor 11-50
(1) Lift and remove Rear bag section from Deck. (Fig. 1)
While holding Handle section (Lower pipe, Upper pipe complete, etc.),
loosen two M6 Thumb screws. (Fig. 1)
Handle section is removed. (Fig. 2)
(2) Remove two Holders 9-19 from Lower pipe.
Remove two M6 Thumb nuts and M6x50 two Cup hex square neck bolts,
and then separate Upper pipe complete from Lower pipe. (Fig. 3)
Lower pipe can be replaced.
(3) Loosen 4x18 Tapping screw, then remove Switch lever case and
Switch lever case cover. (Fig. 4)
(4) Loosen four 4x18 Tapping screws, then remove Switch box cover complete
and Switch box. (Fig. 5)
(5) Remove Tension spring 9, and then separate Lever
and M4x20 Pan head screw with WR (spring washer
and Flat washer) from Switch box and Switch lever.
Upper pipe complete and Lever can be replaced.
(Fig. 6)
1R285
DISASSEMBLING
removing Plane bearing 10 from Front/ Rear wheels
CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.
Fig. 1
Fig. 2
Fig. 3
Fig. 5 Fig. 6
Fig. 4
Lower pipe
Rear bag complete
Deck
M8x35 Thumb screw
(2 pcs.)
Upper pipe complete
Switch lever
Switch box
Switch box cover complete
4x18 Tapping
screw (4 pcs.)
4x18 Tapping
screw
Switch lever case cover
Switch lever case
Switch lever
Lower pipeUpper pipe complete
M8x35 Thumb
screw
M8x35
Thumb screw
Holder 9-19 (2 pcs.)
Lower pipe
M6 Thumb nut
(2 pcs.)
Upper pipe complete
Upper pipe complete
Holder 9-19 (2 pcs.)
M6x50 Cup hex square neck bolt
Tension spring 9
Switch lever
Switch box
Lever
M4x20 Pan head
screw with WR