Filter
Top Products
Repair
P 5/ 8
[2] ASSEMBLY/ DISASSEMBLY
[2]-3. Change lever section
(1) Remove Cowling. (Refer to the previous page.)
(2) Shift Change lever to the position of grass cutting height 75mm.
(3) Detach the hook of Tension spring 16 from the projection of Deck using long-nose pliers. (Fig. 17)
(4) Put a wood under Deck to raise Wheels from the ground. (Fig. 18)
(5) Unscrew two 4x18 Tapping screws, and separate the pin of Connecting rod from the hole of Change lever,
and then remove Change lever section from Deck toward DC motor side. (Fig. 19)
(6) Remove Change lever cover, and then separate screws, bolt and nut as drawn in Fig. 20.
DISASSEMBLING
ASSEMBLING
Fig. 17
Fig. 20
Fig. 19
Fig. 18
Fig. 21
Long-nose
pliers
hook of
Tension
spring 16
Change lever
Change lever
Adjust plate
4x18 Tapping screw
(2 pcs.)
Change lever
M6x30
Hex bolt
Sleeve 6
Change
lever
cover
Adjust plate
Compression spring 9
Flat washer 9
Flat washer 4
M6 Hex nut
4x18 Tapping
screw
Assemble Change lever section in the reverse order of disassembly.
Note: Lift Connecting rod and insert the pin into the hole of Connecting rod. (Fig. 21)
4x18 Tapping
screw (2 pcs.)
Connecting rod
Wood
hole of Change lever
pin of Connecting rod
projection of Deck