Filter
Top Products
26
RTR12 & RTA12 Series (Serial No. 884764-) Rotary Tillers 311-785M
8/12/14
Section 4: Maintenance and Lubrication
Table of Contents
Chaincase
Type = Recommended: Shell Alvania EP00 Oil
Alternate: SAE 90 wt. oil
Quantity = As required
IMPORTANT: Tiller should be level when checking
oil level in chaincase. Check oil level by removing
lower level plug. Oil should reach bottom of plug
hole. Remove fill plug and add recommended oil as
needed. Retighten both plugs when done.
RTA Series RTR Series
30364A
30357A
Level PlugLevel Plug
Fill Plug
Fill Plug
Gearbox
Check oil every 50 hours of operation by removing center
level plug at the rear of the gearbox, oil should come to
bottom of center plug hole. Add recommended gear lube
through fill plug hole until oil begins to flow out of oil level
plug hole. DO NOT OVERFILL!
Retighten all plugs when done.
Type of Lubrication: SAE 80-90W EP Oil
Quantity = Fill until oil begins to flow out of oil level plug
hole.
30358
NOTE: SOME GEARBOXES HAVE THE
FILL PLUG ON THE TOP AND DRAIN
PLUG ON THE BOTTOM.
50
Hours
As
Required
Bearing On Right End Of Rotor Shaft
Type of Lubrication: Multi-Purpose
Quantity = As Required
30356
8
Hours