Filter
Top Products
21
8/12/14
RTR12 & RTA12 Series (Serial No. 884764-) Rotary Tillers 311-785M
Land Pride
Section 3: Adjustments
Table of Contents
Rear Deflector
Refer to Figure 3-4:
Rear deflector (#2) can be adjusted closer to the ground
to produce a fine soil texture or raised to produce a
coarse soil texture. Adjust rear deflector up or down by
repositioning chain (#1) in slot “A”.
Skid Shoe Adjustment
Refer to Figure 3-5:
The skid shoes can be adjusted to the desired tilling
depth by raising or lowering them:
1. Raise tiller off the ground. Place support blocks
under the tiller (not under the skid shoes) and
lower tiller onto the supports. Make certain the tiller
is secured while resting on the supports before
working on or around the tiller.
2. Always place tractor in park, set tractor brakes, shut
tractor engine off and remove switch key before
dismounting tractor.
3. Loosen pivot bolt (#2A) at the shoe’s front.
4. Remove adjusting bolt (#2B) at the shoe’s rear.
5. Adjust skid shoe (#1) up or down to the desired tilling
depth.
6. Reinstall adjusting bolt (#2B) and lock washer (#3).
Tighten adjusting bolt and pivot bolt to the correct
torque.
NOTE: Tilling depth is the vertical distance from
bottom of skid shoes to bottom of lowest tine. Be
certain both skid shoes are adjusted the same.
Rear Deflector Adjustment
Figure 3-4
Skid Shoe Adjustment for Field Operation
Figure 3-5
30354
30350A