Filter
Top Products
18
RTR10 & RTR15 Series Rotary Tillers 311-431M
5/05/06
Land Pride
Section 3: Adjustments
Table of Contents
Skid Shoe Adjustment
Refer to Figure 3-5:
The skid shoes can be adjusted to the desired tilling
depth by raising or lowering them as follows:
1. Raise tiller off the ground. Place a support under the
tiller (not under the skid shoes) and lower the tiller
onto the support. Make certain the tiller is secure
resting on the support before working on or around the
tiller.
2. Always place tractor in park, set tractor brakes, shut
tractor engine off and remove switch key before
dismounting the tractor.
3. Loosen pivot bolt (#1) at the shoe’s front.
4. Remove adjusting bolt (#2) at the shoe’s rear.
5. Adjust skid shoe (#3) to the desired height.
6. Reinstall adjusting bolt (#2) and tighten both the
adjusting bolt and the pivot bolt (#1).
IMPORTANT: Be sure both skid shoes are adjusted
the same.
Skid Shoe Adjustment
Figure 3-5
22252