Filter
Top Products
11
5/05/06
RTR10 & RTR15 Series Rotary Tillers 311-431M
Land Pride
Section 1: Assembly and Set-Up
Table of Contents
Rear Deflector Assembly
Refer to Figure 1-3:
Attach Chain (#2) to rear deflector (#1) with wire
retaining pin (#3). Place 2nd chain loop on opposite end
of chain into slot “A”.
Rear Deflector
Figure 1-3
22250
Tractor Hook-Up
Refer to Figure 1-4:
1. Some tractors are equipped with multi-speed PTO
ranges. Be certain your tractor PTO is set for 540 rpm.
2. Back tractor up to tiller until lower 3-Point links are
aligned with the hitch clevises on the tiller.
3. Secure tractor’s 3-Point lower links to the lower hitch
clevises using 7/8" diameter hitch pins.
4. Secure the tractor’s top link to the tiller top hitch using
a 3/4" diameter hitch pin (supplied by customer).
Adjust tractor top link in order to level the tiller.
5. Prevent damage to the driveline u-joints by adjusting
the tractor’s 3-Point lift height so that the tiller tines are
not lifted more than 14 inches off the ground.
!
WARNING
Damaged drivelines could cause serious injury or death.
IMPORTANT: PTO operation and/or engagement
with unit higher than 14” will damage driveline
components. See Figure 1-4.
Tractor Hook-Up
Figure 1-4
22248