Filter
Top Products
14
Section 2 Operating Instructions
RCR16 Series Rotary Cutters 312-742M
12/14/01
Land Pride
Cutter Height Adjustment
Refer to Figure 2-3:
If the cutting height is too high or too low, the gauge wheel
must be adjusted as follows:
a. Use the tractor’s 3-point hydraulic control to lift the
cutter such that the gauge wheel clears the
ground.
b. Remove the existing hardware; 3/8” -16 x 1" long
carriage bolt (#1) and 3/8” flange nut (#2).
c. Adjust the gauge wheel up or down to the desired
cutting height and replace the hardware.
19753
3-Point Cutter Height Adjustment
Figure 2-3