Filter
Top Products
10
Section 2: Adjustments
GS2584 & GS2596 Grading Scrapers 303-268M
10/29/08
Land Pride
Table of Contents
Shank Height Adjustment
!
CAUTION
Make adjustments to the shank height after the Grading
Scraper has been properly hooked to a tractor to prevent
injury!
!
CAUTION
Always keep your feet and legs out from under the shanks
when adjusting shank height. The shanks can slip from your
grip and fall causing injury to your feet and/or legs.
Top Hole
3 1/2” Below
Third Hole
1/2” Above
26656a
26656c
Second Hole
1 1/2” Below
Fourth Hole
2 1/2” Above
26656b
26656d
Shank Settings
Figure 2-2
!
CAUTION
Keep clear of the shank slots while adjusting shank height.
Shanks can pinch body parts in slots during adjustments!
Refer to Figure 2-2:
Shank settings are based on the vertical distance
measured from bottom edge of skid shoes to bottom
edge of shank tips.
1. Hook Grading Scraper to a tractor with a category I
3-point hitch before adjusting shanks.
2. Adjust shank height by removing hairpin cotter (#1)
and shank lock pin (#2).
3. Adjust shank up or down to the desired depth and
then replace shank lock pins and hairpin cotter.