Filter
Top Products
12
Section 1: Assembly and Set-Up
FDR2572 & FDR2584 Grooming Mowers 310-262M
10/15/07
Land Pride
Table of Contents
e. Cut off inner shield at mark (“X” dimension). Cut
same amount off inner shaft (“X1” dimension).
Repeat cut off procedure (“Y”&“Y1” dimensions)
to cut outer driveline half.
f. Remove all burrs and cuttings.
5. Apply multi-purpose grease to the inside of the outer
driveline profile and reassemble the two profiles.
6. Attach inner driveline yoke to gearbox shaft and
outer driveline yoke to tractor's PTO shaft.
7. The driveline should now be moved back and forth to
insure that both ends are secured to the PTO shafts.
Reattach any end that is loose.
8. Hook one driveline safety chain in the hole on the
outer driveline yoke shield and the opposite end to
the tractor.
9. Hook the second driveline safety chain in the hole on
the inner driveline yoke shield and the opposite end
to the mower.
10. Start tractor and raise mower just enough to remove
support blocks used in step 4a on page 11.
11. Slowly engage tractor’s 3-point controls to lower
mower.Check for sufficient drawbar clearance. Move
drawbar ahead, aside or remove if required.
IMPORTANT: The two supplied safety chains must
be attached to outer and inner driveline yoke shields
and to the mower deck and tractor to keep driveline
shields from rotating.