Filter
Top Products
10
Section 1: Assembly and Set-Up
FDR2572 & FDR2584 Grooming Mowers 310-262M
10/15/07
Land Pride
Table of Contents
Front Roller
Refer to Figure 1-3:
1. Remove the front two 1/2”-13 x 1 1/2” GR5 hex flange
serrated screws (#9) and reinsert from the bottom as
shown. Secure with existing 1/2” whiz nuts (#10).
Tighten nuts to 76 ft-lbs of torque.
2. Assemble brackets (#2) and (#3) to deck with
carriage bolts (#4) and flange nuts (#5).
3. Insert roller (#8) between brackets and install pin
(#1) through brackets and roller. Secure with washer
(#6) and cotter pin (#7).
Front Roller Assembly
Figure 1-3
17713
Tractor Hook-Up
1. Be certain that tractor draw bar will not interfere.
Move draw bar ahead or remove if required. Draw bar
should also be checked for clearance when unit is
being raised for the first time.
2. Align lower link arms of tractor to hitch clevises on
mower. Insert lower hitch pins into lower ball swivels
and attach linch pins.
3. Attach tractor top link to upper floating hitch on
mower with pin supplied. Secure with lock pin.
4. Adjust the tractor top link in or out to place the upper
hitch pin vertically above the lower hitch pins as
shown in Figure 1-4, to allow mower flotation.
Tractor Hook-Up
Figure 1-4
17366