Filter
Top Products
23
Operation Instructions
Note! Read the Important Safety Information section first.
WARNING! The spray plate holes must be kept clear. The spray plate should be
regularly removed and cleaned in descalent. Lack of regular spray plate cleaning will
lead to poor performance and cause early failure of the appliance. See the shower
fittings User Guide for more information.
To turn the shower on
1. Switch on the electrical supply at the double pole
switch.
2. Turn the power knob to High. Wait 15–20 seconds
for warm water to reach the handset.
For electrical economy, set the power knob to
Medium. This setting will provide sufficient power
when the supply water temperature is warmer,
such as in the summer.
For an unheated shower, set the power knob to
Low.
To set the shower temperature
1. Set the shower temperature by rotating the
temperature knob as necessary. Turn the knob
clockwise for hotter water and anticlockwise for
cooler water. Wait 10–15 seconds for the adjusted
temperature to reach the handset.
Note! It is normal for the flow rate to change when
the temperature is changed.
Note! If the water temperature cycles between hot
and cold, the temperature is set too high. This is
causing the thermal switch to turn off the heating
element to reduce the water temperature. Turn
the temperature knob anticlockwise to reduce the
water temperature.
Cooler
Hotter