Filter
Top Products
18
12. Secure the shower to the wall
loosely through the top two fixing
holes, using the supplied screws.
13. Mark the position of the bottom
fixing hole.
14. Remove the shower from the wall.
Drill the bottom fixing hole and insert
the supplied wall plug.
15. Thoroughly flush the mains-fed
cold water supply pipe. The
supply must be clean and free
from debris BEFORE connecting
the appliance.
16. Replace the shower on the wall and
secure through the three fixing holes,
using the supplied screws.
Screws
17. Connect the inlet supply pipe to the
inlet connector using a 1/2” BSP
nipple with compression nuts and
olives (shown) or a push-fit
connector.
Inlet Connector
Compression
Nut
Olive
1/2” BSP Nipple
Olive
Compression
Nut
Inlet Supply Pipe