Filter
Top Products
TP-6905 6/14 43Section 3 RDC2 Controller Operation
3.17.1 Networking Status Submenu
The Networking Status submenu contains settings for
OnCuer Plus. See the OnCue Plus Software
Operation Manual for information about the appropriate
network settings for OnCue Plus.
If DHCP is enabled, IP parameters are not displayed. If
DHCPis disabled (i.e.,if a static IP address is used), the
IP parameters are displayed.
To enable or disable DHCP and change the IP settings,
go to the Networking Configuration menu. See
Section 3.17.2.
tp6804
IP Address:
###.###.###.###
Gateway:
###.###.###.###
<---- Return
Subnet Mask:
###.###.###.###
DHCP:
Enabled
Ethernet Status:
Disconnected
DNS 1:
###.###.###.###
DNS 2:
###.###.###.###
OnCue Server:
###.###.###.###
OnCue Status:
Connected
Networking---->
Status
Networking---->
Information
Figure 3-18 Network Status Submenu