Filter
Top Products
10
English
Notes:
• When connecting a CD recorder to the TAPE/CDR jacks, change the
source name to CDR so that “CDR” appears on the display when
selected as the source. See “Changing the Source Name” below.
• When you have connected some digital source components using
the digital terminals (see page 9), you need to select the digital input
terminals (see page 14).
• When you press one of the source selection buttons on the remote
control marked with an asterisk (
*
), the receiver automatically turns
on.
Turning On the Power
Press STANDBY/ON (or STANDBY/ON AUDIO on the
remote control).
The STANDBY lamp goes off. The name of the current source
(or station frequency) appears on the display.
To turn off the power (into standby mode)
Press STANDBY/ON
(or STANDBY/ON AUDIO on the
remote control) again.
The STANDBY lamp lights up.
Note:
A small amount of power is consumed in standby mode. To turn the
power off completely, unplug the AC power cord.
Selecting the Source to Play
Press one of the source selection buttons.
The selected source name appears on the display.
On the front panel
From the remote control
DVD: Select the DVD player.
VCR: Select the VCR.
TV SOUND: Select the TV sound.
CD*: Select the CD player.
TAPE/CDR*: Select the cassette deck (or the CD recorder).
FM/AM*: Select an FM or AM broadcast.
• Each time you press the button, the band
alternates between FM and AM.
Basic Operations
STANDBY/ON
AUDIO
Source selection
buttons
Front panel Remote control
Source selection
buttons
STANDBY/ON
and STANDBY lamp
SOURCE NAME
FM/AMTAPE/CDR
CD
TV SOUNDVCR
DVD
TAPE/CDR CD DVD
FM/AM TV SOUND VCR
ANALOG
/DIGITAL
Changing the Source Name
When you have connected a CD recorder to the TAPE/CDR
jacks on the rear panel, change the source name to CDR so
that “CDR” appears on the display when selected as the
source.
1
Press TAPE/CDR (SOURCE NAME) on the
front panel.
• Make sure “TAPE” appears on the display.
2
Press again and hold SOURCE NAME
(TAPE/CDR) on the front panel until
“ASSIGN CDR” appears on the display.
To change the source name from “CDR” to “TAPE,” repeat
the same procedure above (in step
1
, make sure “CDR”
appears on the display).
Note:
Without changing the source name, you can still use the connected
components; however, you may experience one of the following
inconveniences:
• A different source name will appear on the display when you select
the target component.
• You cannot use the digital input (see page 14) for the CD recorder.
• You cannot use the COMPU LINK remote control system (see page
26) to operate the target component.
Remote
NOT
SOURCE NAME
TAPE/CDR
CD FM/AM
RX–5032V
AUDIO/VIDEO CONTROL RECEIVER
1
4
7/P
10
2
5
8
0
3
6
9
10
TA/NEWS/INFO
DISPLAY MODE
A/V CONTROL
RECEIVER
SOURCE NAME
10-15_RX-5032V[US]f 03.2.5, 18:5810