Filter
Top Products
MAINTENANCE
19
MTF-041007C
HOW TO REPLACE THE AUGER
1. Remove the belt cover. See “How To Remove The Belt
Cover”.
2. Remove the drive belt. See “How To Replace The Drive
Belt”.
3. Remove the auger pulley from the auger shaft
(threads are left hand; turn clockwise to remove). (See
Figure 18).
4. To keep the auger from rotating, set a 2”x4” piece of
wood on the center paddle to secure auger.
5. Remove the fasteners from the bearing assembly. Re-
move the bearing assembly from the auger housing.
6. Slide the auger out of the bearing assembly on the
right side of the snow thrower.
7. Tip the auger enough to allow the auger to slide out of
the auger housing.
8. To install auger, reverse the above steps.
Figure 18
Bearing Assemlby
Auger Pulley
Auger Housing
Auger
Center Paddle
Wood