Filter
Top Products
SERVICE RECOMMENDATIONS
15
MTF-041007C
SERVICE RECOMMENDATIONS
PROCEDURE
FIRST
2
HOUR
BEFORE
EACH
USE
OFTEN
EVERY
5
HOURS
EVERY
10
HOURS
EVERY
25
HOURS
BEGINNING
EACH
SEASON
BEFORE
STORAGE
S
N
O
Tighten all screws and nuts
√ √
√
O
W
T
H
Lubricate Chute Control
Flange
√ √
H
R
O
W
E
Check Auger Drive Cable
Adjustment
(See Cable Adjustment)
√
E
R
Check Drive Belt
√
The warranty on this snowthrower does not cover items that
have been subjected to operator abuse or negligence. To re-
ceive full value from the warranty, operator must maintain
snowthrower as instructed in this manual. The following Ser-
vice Recommendations is supplied to assist operator to
properly maintain snow thrower. This is a check list only. Ad-
justment referred to will be found in the MAINTENANCE sec-
tion of this manual.
AFTER EACH USE
1. Check for any loose or damaged parts.
2. Tighten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the
snowthrower to prevent freezing of auger or controls.
5. Check controls to make sure they are functioning
properly.
6. If any parts are worn or damaged, replace immediately.
LUBRICATION
Before Storage
1. Lubricate the chute control flange. Apply a clinging
type of grease such as Lubriplate.
Figure 9
Chute Control
Flange