Filter
Top Products
6
DEALER SETUP
Tine Arms
Remove the rubber cap from the gearbox shaft. Slide
the tine arm onto the shaft. Line up the hole and in-
sert the M10 metric socket head bolt. Place one of
the cupped washers on either side of the tine arm and
tighten the locknut. Repeat for all 9 arms.
Guard Support Arms
Attach the guard support arms to both sides of the rake
using the 1/2” bolts. NOTE: The guard arm with the
curtain mount tube is for the left side of the rake.
Guards, Front
Attach the front half of the guard to the main frame us-
ing the 3/8 x 1 bolts, lockwashers & nuts. Repeat both
sides.
Tines
Attach three tines to each arm using the 1/2 x 3-1/4
Grade 8 bolts. Insert bolt from the top and clamp the
tine in place with the 1/2” heavy washer and locknut.
Torque to 60-65 ft.-lbs.