Filter
Top Products
ASSEMBLY
Assembly 31
Final Inspection and Adjustments
IMPORTANT: PTO driveline may be too long for some tractor models, causing tractor transaxle damage.
Modify driveline if necessary.
Attach rotary cutter to tractor and check cutter-to-tractor driveline telescoping length clearance.
(See
CHECKING DRIVELINE/CUTTER CLEARANCE in Attaching section.)
IMPORTANT: Blade hardware MUST be checked after the first hour and every eight (8) hours thereafter.
Check blade hardware torque. Re-tighten hardware after one hour of operation and every eight (8) hours thereafter.
(See MAINTENCE BEFORE EACH USE in Lubrication and Maintenance section.)
MODIFY PTO DRIVELINE
MODIFY PTO DRIVELINE
• Modify PTO Driveline (If Necessary)
1. To adjust the length, hold the half-shafts next
to each other in the shortest working position
and mark them.
2. Shorten inner and outer guard tubes equally.
3. Shorten inner and outer sliding pro les by
the same length as the guard tubes.
4. Round off all sharp edges and remove burrs.
Grease sliding pro les. No other changes may
be made to PTO drive shaft and guard.
5. Chains must be tted so as to allow suf cient
articulation of the shaft in all working positions.
6. The PTO drive shaft must not be suspended
from the chains!