Filter
Top Products
Service - 7
SERVICE
Operational Tips
• Always operate your spreader with the speed limit for which it was
designed - 3 mph.
• When backing, carefully back straight to avoid jack knifing, which could
result in damage to equipment.
• Only tow your spreader behind vehicles for which it was designed -
riders, and lawn and garden tractors.
• Do not load the hopper with more than the maximum weight capacity of
79 kg (175 lb).
• When spreading ice melters, pin both wheel hubs for better traction.
• When spreading seed, fertilizer, etc., insert only one spring locking pin in
either the right or left wheel hub.
• Break up any lumps as you fill the hopper.
• Do not use on windy days, especially when spreading fine grass seed or
herbicides.
• Optimum hitch height is 18 - 23 cm (7- 9 in.).
Service
Maintenance Tips
• The key to years of trouble-free service is to keep your spreader clean
and dry.
• Never allow material to remain in hopper for extended periods of time.
• Should rust develop, sand lightly and then paint area with enamel.
• Periodically check all fasteners for tightness.
• Rinse/dry inside and outside of spreader after each use. Move flow
control as you rinse, to avoid build up of material.
Annual Maintenance
MX39211
1. Remove snap ring (A), 5/8 in. flat washer (B), wheel (C), washers (D) (if
installed), and axle bearing (E).
MX39212
2. Remove spring locking pin (F), and slide axle (G) out from support
frame (H).
3. Clean parts.
4. Lightly lubricate both axle bearings.
5. Remove two locknuts (I) and support tube (J) from bolts on frame.
6. Remove 1/8 x 1 in. cotter pin (K), agitator (L), and 3/8 in. ID O-ring (M),
and transmission (N).
7. Clean fan (O).
A
B
C
E
D
G
H
O
N
F
K
L
M
I
J