Filter
Top Products
Assembly - 3
ASSEMBLY
Assemble Hopper to Frame
MX34596
1. Install six 1/4 x 1-3/4 in. hex bolts (A), and 1/4 in. thrust washer (B)
through top of hopper (C) and through support frame (D), as shown.
Secure bottom of bolt with 1/4 in. locknut (E). To avoid damage to plastic,
do not overtighten hardware.
MX38961
2. Install tow tube (F) onto support frame (D) with two 5/16 x 3 in. hex bolts
(G) and 5/16 in. hex nuts (H). Tighten hardware and torque bolts to 30
N•m (22 lb-ft), or one complete turn after finger tight.
Install Transmission and Wheels
MX38960
1. Install lock clip (A) and fan driver (B), with small diameter lip of driver
toward the bottom, as shown.
2. Slide fan (C) onto transmission assembly (D) shaft over top of fan driver.
Move lock clip, fan driver, and fan downward so top of fan is approximately
12.7 cm (5 in.) (E) from top of transmission shaft.
C
D
A
B
E
D
G
H
F
A
C
B
D
E