Filter
Top Products
Installation Instructions
OUZXMAG,0001BF6 –19–18NOV03–2/2
6. Press key C to select “SPFH Network” and check
communication between SPFH and Harvest Monitor.
7. Press RUN key.
OUZXMAG,0002084 –19–04AUG05–1/1
Check Inoculant Dosing Functionality
ZX1035268 –UN–26JUL04
1. Turn ignition key to start harvester engine.
2. Press “SETUP” key to enter SETUP mode.
3. Press key A in “SETUP” to select “Harvest Mon”.
4. Press “PAGE” key to go to “SETUP - Harv Mon -
PAGE 2” screen then press key “F” to toggle inoculant
dosing support state from OFF to ON or vice versa.
5. Press RUN key.
6. The inoculant dosing device can be engaged if:
• The road safety switch is in field operating mode
• The forage harvester is travelling forward
• The ground speed is greater than 2 km/h (1.24 mph)
• The feedrolls are turning in forward direction
• The header is in harvesting position
7. Press once the liquid injection pump switch (A). Carry
out a test to make sure that inoculant device is
properly connected to the wiring harness AZ101120.
If this is not the case check wiring harness connection
or contact your John Deere dealer.
NOTE: For a proper use of the liquid injection pump
switch (A), refer to the forage harvester Operator’s
Manual.
Z103757 (13DEC06)
27
Installation Instructions
011507
PN=29