Filter
Top Products
TV Installation
Remove back cover by lifting straight upward and then
remove the drip shield. Tighten cable tie and cut off
excess. Tighten cable tie with anchor (not supplied) to
the TV power cord. It is not necessary to attach anchor
to drip shield; the cable tie and anchor are used to
ensure the TV power cord remains in the TV housing.
Locate blackout panel and peel protective backing off
adhesive. Position blackout panel onto TV screen and
press adhesive to TV. Position TV on shelf and hook up
power cord, audio and cable TV cables. Slide TV flush
to front window. Make sure the sensor hole on the
blackout panel aligns with the TV sensor. If they do not
align, adjust the shelf with positioning feet till they are
aligned. Reinstall drip shield. Connect speaker wires to
back cover speakers observing polarity: right speaker
purple + and purple w/black stripe -; left speaker green
+ and green w/black stripe -. Then position back cover
by sliding downward over gasket seal. Make sure
gasket seal did not detach from bath shell (extra gasket
material has been provided). Secure with screws (an
offset screwdriver is provided). An internal fan is pro-
vided to cool and ventilate the TV compartment. The fan
will turn on in some instances depending on the thermo-
stat within the TV compartment.
RED
BLACK
FAN
AUDIO
CABLE
TV POWER CORD
CABLE TV
DRIP SHIELD
DRIP SHIELD WIRING
TO CABLE TV LINE
TO STEREO AUDIO
INPUT OF CD/RADIO
REAR OF TV
DC INPUT
TV CONNECTIONS
VIDEO/AUDIO FROM
EXTERNAL DVD OR VCR
DRIP SHIELD
BLACKOUT PANEL
POWER, AUDIO AND
CABLE TV/ANT. CABLES
DOUBLE SIDED TAPE
TOP AND BOTTOM
PEEL PROTECTIVE
BACKING OFF ADHESIVE.
GENTLY PUSH TV AS
FAR FOWARD TO WINDOW
REMOTE
CONTROL
SENSOR
BACK COVER
SCREWS (3)
SPEAKER WIRES
6