Filter
Top Products
9
Remote Control
LED INDICATOR
BATH MODE
CHANNEL UP & DOWN
JETS FUNCTION
LIGHT FUNCTION
TV MODE
VOLUME UP & DOWN
CD/DVD FUNCTION
BLOWER FUNCTION
POWER
The Floating Remote Control is a universal remote control that has been programmed to operate the TV. If the
remote has been deprogrammed the following procedure will reprogram the remote:
For TV
1. Press and release the TV button.
2. Press and hold the BLOWER button. The LED will flash.
3. While holding the BLOWER button, press the POWER button for 2 seconds until the LED lights up. Then
release both buttons.
4. Enter the 5 digit code 12343 using the VOLUME up and down and CHANNEL up and down: Volume up = 1,
Volume down = 2, Channel up = 3 and Channel down = 4.
5. The LED will shut off if the code is accurate and the setting successful. If not, the LED will flash twice and the
procedure must be repeated starting from step 1.
For Bath
1. Press and release the Bath button.
2. Press and hold the BLOWER button. The LED will flash.
3. While holding the BLOWER button, press the POWER button for 2 seconds until the LED lights up. Then
release both buttons.
4. Enter the 5 digit code 24332 using the VOLUME up and down and CHANNEL up and down: Volume up = 1,
Volume down = 2, Channel up = 3 and Channel down = 4.
5. The LED will shut off if the code is accurate and the setting successful. If not, the LED will flash twice and the
procedure must be repeated starting from step 1.
ACTIVATING THE WHIRLPOOL BATH (aim remote at sensor on bath)
1. Pressing the BATH button allows access to the JETS , LIGHT BLOWER functions.
2. Press the LIGHT button once to activate the lights; press again to deactivate.
3. Press the JETS button once to activate the jets; press again to deactivate.
4. Press the BLOWER button once to activate the blower; press again to deactivate.
NOTE: Jets, light and blower will automatically turn off after 30 minutes.