Filter
Top Products
Wall Cutout and CD/Radio Installation
The installation requires a cutout in the wall. The cutout allows room for the speakers, CD/Radio speaker/power &
TV audio cable wires.
NOTE: CD/Radio must be must be located a minimum of 5' away from the interior of the bath. The cable provided
with the unit is designed for this minimum distance. If a longer distance is desired, cut the cable and splice to the power
cord with leads provided with the CD/radio. Do not exceed 20' as the CD/radio audio performance will be reduced and
damage to the unit can occur.
Before final setting of the bath, locate the CD/radio speaker & power harness, TV audio cable and CD/Radio ground-
ing wire (CD/Radio chassis to control box bonding bar) coiled under the bath rim. Run wires through wall cutout to
CD/Radio build out.
38"
9" MIN.
BATH
PERIMETER
1x4 (NOT
FOR SUPPORT)
FINISHED
WALL
4" MIN.
CABLE TV OUTLET
CD/RADIO -
MAY BE LOCATED ON
OPPOSITE WALL
JUNCTION BOX
(FOR HEATER)
TV AUDIO
CABLE
CUTOUT
CUTOUT IN
WALL (SAME
SIDE AS
MOUNTED
CD/RADIO)
5' MINIMUM
JUNCTION BOX
(POWER TO
CONTROL BOX)
To allow clearance for the CD/Radio, build-out section of
wall 7-1/2" from back of stud as shown. We recommend
using 1/2" plywood. A template is provided for sleeve
mounting hole on page 13. Keep CD/Radio build-out
away from insulating materials.
NOTE: CD/Radio has been mechanically fastened to
the bottom of the TV shelf. Remove before installing
unit.
Before mounting, press control panel release button and
detach control panel
FINISHED WALL
7-1/2"
4