Filter
Top Products
Remove trim plate. Remove sleeve after disengaging sleeve locks. Stand
the unit and insert the 2 handles between the unit and
sleeve to disengage the sleeve locks. When standing
the unit be careful not to damage the fuse on the rear.
Remove the sleeve. Retain the handles for future use.
Run wires through sleeve. Insert sleeve into build out. When flush, bend appropriate tabs to hold sleeve firmly in
place. Connect the speaker & power connector and TV audio to the CD/radio. Connect the green ground wire to the
CD /radio chassis ground.
Slide Unit into sleeve until locked. Attach trim plate and control panel.
ANTENNA
SPEAKER
& POWER
HARNESS
GROUND
TERMINAL
FUSE
TV
AUDIO
CABLE
CONTROL
PANEL
TRIM
PLATE
CD/RADIO
CHASSIS
SLEEVE
BUILT OUT
AREA
5