Filter
Top Products
25
Suction Cover/Strainer Maintenance
Clean the suction cover/strainer of hair and debris when
necessary. To do this, remove the center screw and
detach the square cover. Clean the cover by backflush-
ing debris from the holes. Replace the suction cover
immediately after cleaning. When reinstalling, orient the
cover/strainer with the small notch at the bottom. The
gasket must be inserted into the groove of the cover/
strainer before reinstalling onto the suction fitting.
CAUTION: Keep hair a minimum of 6 inches away
from the suction fitting at all times when the whirl-
pool system is operating. Hair longer than shoulder
length should be secured close to the head, or a
bathing cap should be worn. Do not operate the
whirlpool system with the suction cover removed! It
is a safety device and must always be in place on the
suction fitting to minimize the potential hazard of
hair and body entrapment.
NOTCH
GASKET
COVER STRAINER
SCREW
SUCTION
FITTING
SUCTION COVER/STRAINER ASSEMBLY
DOME CLEANING
For routine cleaning of the dome, use a mild liquid
detergent. Do not use cleaners containing abra-
sives, alcohol, ammonia or other solvents.