Filter
Top Products
J-Allure
Water Supply
Consult local authorities for plumbing code requirements in your area.
IMPORTANT: Proper installation of the fill spout plumbing and compliance with local codes are the
responsibility of the installer. Jacuzzi Whirlpool Bath does not warrant connections of water supply fittings
and piping, fill systems, or drain/overflow systems. Nor is it responsible for damage to the bath which occurs
during installation.
CAUTION: A nonflammable protective barrier must be placed between soldering work and bath unit to prevent
damage to the bath.
10
Clean-Up After Installation
To avoid dulling and scratching the surface of the bath, never use abrasive cleaners. A mild liquid detergent and warm
water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal tools will scratch the surface. Spots left by plaster or grout
can be removed if lightly rubbed with detergent on a damp cloth or sponge.
Paint, tar, or other difficult stains can be removed with paint thinner, turpentine, or isopropyl alcohol (rubbing alcohol).
Minor scratches which do not penetrate the color finish can be removed by lightly sanding with 600-grit wet/dry
sandpaper. You can restore the glossy finish to the acrylic surface of the bath with a special compound, Meguiar's
#10 Mirror Glaze. If that is not available, use automotive rubbing compound followed by an application of automotive
paste wax.
Major scratches and gouges which penetrate the acrylic surface will require refinishing. Ask your Jacuzzi Whirlpool
Bath dealer for special instructions.
RIGHT SIDE WALL
RECOMMENDED
FILL SPOUT
LOCATION
HOT & COLD SUPPLY VALVE LOCATION
RIGHT SIDE WALL
BATH CONTROLS
SIDE WALL
FRAME
APPROX.
1-1/2"
Hot and Cold Supply Valve & Fill Spout Locations