Jacuzzi J - 480 Swimming Pool Vacuum User Manual


 
Page 43
J-400 Series
13.0 Spa Maintenance
Proper and regular maintenance of your spa will help it retain its beauty
and performance. Your authorized Jacuzzi dealer can supply you with
all the information, supplies, and accessory products you will need to
accomplish this.
DANGER: RISK OF SEVERE INJURY OR DROWNING BY
ENTRAPMENT!
Keep hair, loose articles of clothing or hanging jewelry away from
suction ttings, rotating jets or other moving components to avoid
entrapment that could lead to drowning or severe injury.
Never use the spa unless all suction guards, lter, lter lid, or skim-
mer assembly are installed to prevent body and/or hair entrapment.
Never operate or use the spa if the lter, lter lid, or skimmer assem-
bly are broken or any part of the skimmer assembly is missing.
Please contact your dealer or nearest service center for service.
The suction ttings and suction covers in this spa are sized to match
the specic water ow created by the pump(s). If it is necessary to
replace the suction ttings, suction covers or pump(s), be sure that
the ow rates are compatible and are in compliance with the VGB
Safety Act page 2.
Never replace a suction tting or suction cover with one rated less
than the ow rate marked on the original suction tting. Using
improper suction ttings or suction covers can create a body or hair
suction entrapment hazard that may lead to drowning or severe
injury.
Owners must alert all spa users to the potential risk of Hair, Limb,
Body, Evisceration (disembowelment), and Mechanical Entrapment,
page 6.
!
13.1 Cleaning the Filter Cartridges
A programmable “Change Filter” reminder icon ashes on the control
panel display after a specied number days to remind you to clean the
skimmer lter and to check the polishing bag lter. This reminder must
be reset at each lter cleaning interval. Refer to section 12.7 (page 41)
for additional information and programming details. Your new spa is
equipped with an advanced 2-stage ltration system. Fine debris are
ltered by the circulation pump drawing water through the ProClear™
skimmer and pleated lter cartridge 24 hours (unless programmed
otherwise). Large debris are ltered when either jets pump is running
when the spa is in use or during a programmed lter cycle. These pumps
draw water from footwell suction tting and through a secondary water
polishing bag lter. The exclusive footwell “sweeper” suction tting
enhances ltration in the footwell area by creating a “swirling” water
motion to maximize particle agitation and pickup.